Please enable JavaScript to view this site.

 Network Analyzers using RVNA and RNVNA software

Display  |   Print  |   Files   |   Analysis   |   Marker  |   Average  |   Calibration


Stimulus  |   Trigger  |   Scale   |   Channels   |   Trace  |   System   |   Devices*   |   Remote Only


Trigger | Trigger Input | Trigger Output | Remote Only


note

This icon Read only indicates a read only command. This icon Write only indicates a write only command.

This icon Remote only indicates command(s) without equivalent softkeys.

Comments are in italics.


Trigger

Trigger Mode:

Continuous

INIT:CONT

Single Write only

INIT

Trigger Source (Internal | External | Bus)

TRIG:SOUR

 

Trigger Input

Event (On Sweep | On Point)

TRIG:POIN

Polarity (Negative Edge | Positive Edge)

TRIG:EXT:SLOP

Position (Before Sampling | Before Setup)

TRIG:EXT:POS

Delay

TRIG:EXT:DEL

 

Trigger Output

Enable Out (ON/OFF)

TRIG:OUTP:STAT

Polarity (Negative Edge | Positive Edge)

TRIG:OUTP:POL

Position (Before Setup | Before Sampling | After Sampling | Ready for Trigger | Sweep End | Measurement)

TRIG:OUTP:FUNC

 

Trigger Remote only

Restart Write only

ABOR

Generates the trigger signal Write only

TRIG

*TRG

Generates the trigger signal; the command is pending until the sweep end Write only

TRIG:SING

Waits for completion of all pending commands Write only

*WAI

Sets the OPC bit of standard event status register upon completion of all pending commands Write only

*OPC

Reads "1" upon completion of all pending commands Read only

*OPC?

Current state of the trigger system Read only

TRIG:STAT?

Waits for the specified trigger state to be reached Write only

TRIG:WAIT

 

Rev.:  24.1