The instrument status bar is located at the bottom of the screen.
Field Description |
Message |
Instrument Status |
Note |
---|---|---|---|
DSP status |
Not Ready |
No communication between DSP and PC. |
|
Loading |
DSP firmware is loading. |
||
Ready |
DSP is running normally. |
||
Sweep status |
Measure |
A sweep is in progress. |
For a detailed description see Trigger Settings. |
Hold |
A sweep is on hold. |
||
Bus |
Waiting for Bus trigger. |
||
RF signal |
RF Off |
Stimulus signal output is turned OFF. |
For a detailed description see RF Out Function. |
Display update |
Update Off |
Display update is turned OFF. |
For a detailed description see Screen Update Setting. |
System correction status |
System Correction Off |
System correction is turned OFF. |
For a detailed description see System Correction Setting. |
Factory calibration error |
System Cal Failure! |
Calibration data in ROM has an error. The analyzer is damaged and requires factory repair. |
|
Power Failure! |
|||
External power meter status |
Power Sensor: Error |
Error connecting an external power meter to the analyzer via USB. |
For a detailed description see Power Meter Setting. |
Overload Protection |
Port <n> Overload! |
Port n overload. |
For a detailed description see Power Trip Function. |