Please enable JavaScript to view this site.

 Network Analyzers using TRVNA software

The trigger initiation mode determines how many trigger signals the Analyzer will accept. The trigger system can operate in one of the following three modes (See the table below).

Trigger Initiation Mode

Function

Continuous

[default]

The Analyzer accepts an infinite number of trigger signals, the measurement cycle is executed every time a trigger signal is detected. The measurement cycle includes sequential measurement of all opened channels one after another.

Single

The Analyzer accepts one trigger signal. One measurement cycle is executed at one trigger signal detection after the mode has been enabled. The measurement cycle includes sequential measurement of all opened channels one after another.The trigger system turns to Stop state after the measurement cycle is complete.

Hold

The Analyzer accepts no trigger signals. The trigger system is in Stop state.

Trigger continuous

Hold softkey

Single softkey

Continuous dot

To set the trigger initiation mode, use the following softkeys:

Stimulus > Trigger

Then select the required trigger initiation mode:

Hold

Single

Continuous

 

 

 

 

Rev.:  24.1