SCPI Command
SENSe<ch>:PLS2:ADVanced:PGEN<png>:TRIGger {PGEN1...PGEN7|EXT1...EXT6|SYNC1|SYNC2}
SENSe<ch>:PLS2:ADVanced:PGEN<pg>:TRIGger?
Description
Sets the trigger source of pulse generator PG1...PG6. Note: The command is used in advanced mode, it is not used in basic pulse modes. Application requires knowledge of the internal structure of the analyzer. Note: S5243 model only. |
|---|
command/query |
Target
Channel <Ch> = {[1]|2| ... 16},
Generator <pg> = {1|2|3|4|5|6|7}
Parameter
<char> defines the trigger source:
PGEN1...PGEN7 |
Generator PG1...PG7 |
EXT1 |
"Ext Trig Out" signal |
EXT2 |
"Ext Trig In" signal |
EXT3 |
"Pulse Trig 3" signal |
EXT4 |
"Pulse Trig 4" signal |
EXT5 |
"Pulse Trig 5" signal |
EXT6 |
"Pulse Trig 6" signal |
SYNC1 |
Internal line SYNC1 signal |
SYNC2 |
Internal line SYNC1 signal |
Query Response
{PGEN1...PGEN7| EXT1...EXT6 | SYNC1 | SYNC2 }
Related Commands
Equivalent Softkeys
Stimulus > Pulse Meas > Advanced Settings... -> Pulse Generators -> Start
Equivalent COM Command
None
Back to Pulse Measurement S5243
Back to Command Finder (From User Interface)
