SCPI Command
SENSe<ch>:PLS2:ADVanced:LINK:NMOD {PGEN1...PGEN7|EXT1...EXT6|LOW|HIGH|SYNC2}
SENSe<ch>:PLS2:ADVanced:LINK:NMOD?
Description
Sets the signal source at the input of the standard modulator. The signal source is determined by the command parameter. A high signal level opens the pulse modulator. Note: The command is used in advanced mode, it is not used in basic pulse modes. Application requires knowledge of the internal structure of the analyzer. Note: S5243 model only. |
|---|
command/query |
Target
Channel <Ch> = {[1]|2| ... 16}
Parameter
<char> signal source at the input of the standard modulator:
PGEN1...PGEN7 |
Generator PG1...PG7 |
EXT1...EXT6 |
"Ext Trig Out", "Ext Trig In", "Pulse Trig (3...6)" signal |
SYNC2 |
Internal line SYNC2 signal |
LOW |
Constant low level |
HIGH |
Constant high level |
Query Response
{PGEN1...PGEN7|EXT1...EXT6|LOW|HIGH|SYNC2}
Related Commands
Equivalent Softkeys
Stimulus > Pulse Meas > Advanced Settings... > Std Modulator -> {source}
Equivalent COM Command
None
Back to Pulse Measurement S5243
Back to Command Finder (From User Interface)
