Please enable JavaScript to view this site.

 Network Analyzers using S2VNA software

The sweep range should be set for the linear and logarithmic frequency sweeps (Hz) and for the linear power sweep (dBm).

The sweep range can be set using either Start/Stop or Center/Span values.

The channel to which the function is applied must be preselected as active (See Selection of Active Trace/Channel).

Stimulus

Start 300 kHz

Stop 3.2 GHz

To enter the start and stop values of the sweep range, use the following softkeys:

Stimulus > Start

Stimulus > Stop

 

Center 1.6

Span 3.19

To enter center and span values of the sweep range, use the following softkeys:

Stimulus > Center

Stimulus > Span

 

 

 


note

If span is set to zero the CW Time Sweep Mode is automatically turned ON.



note

If power sweep is activated, the values on the Start, Stop, Center and Span softkeys will be represented in dBm.



note

The Start, Stop, Center and Span values of the sweep range can be set using the mouse (See Sweep Start Setting, Sweep Stop Setting, Sweep Center Setting, Sweep Span Setting).

Switch between Start/Center and Stop/Span modes with the mouse (See Switching Between Start/Center and Stop/Span Modes).

The Start/Center and Stop/Span values can be set using the mouse (See Start/Center Value Setting, Stop/Span Value Setting).


 

Rev.:  24.2