SCPI Command
SENSe<ch>:PLS2:ADVanced:LINK:STRG {EXT1...EXT6}
SENSe<ch>:PLS2:ADVanced:LINK:STRG?
Sets the signal source at the input of the trigger of standard mode (non-pulse). The signal source is determined by the command parameter. Note: The command is used in advanced mode, it is not used in basic pulse modes. Application requires knowledge of the internal structure of the analyzer. Note: S5243 model only. |
---|
command/query |
Channel <Ch> = {[1]|2| ... 16}
<char> source of standard mode trigger:
EXT1 |
"Ext Trig Out" signal |
EXT2 |
"Ext Trig In" signal |
EXT3 |
"Pulse Trig 3" signal |
EXT4 |
"Pulse Trig 4" signal |
EXT5 |
"Pulse Trig 5" signal |
EXT6 |
"Pulse Trig 6" signal |
{EXT1...EXT6}
EXT2
Stimulus > Pulse Meas > Advanced Settings... > Std Mode Trigger
Equivalent COM Command
None
Back to Pulse Measurement S5243
Back to Command Finder (From User Interface)