SCPI Command
SENSe<ch>:PLS2:ADVanced:CONNector<n>:DIRection {INP|OUTP}
SENSe<ch>:PLS2:ADVanced:CONNector<n>:DIRection?
Description
Sets the signal direction (IN or OUT) for the specified connector on the analyzer's rear panel. Note: The command is used in advanced mode, it is not used in basic pulse modes. Application requires knowledge of the internal structure of the analyzer. Note: S5243 model only. |
|---|
command/query |
Target
Channel <Ch> = {[1]|2| ... 16};
Connector <n>:
1 |
"Ext Trig Out" |
2 |
"Ext Trig In" |
3 |
"Pulse Trig 3" |
4 |
"Pulse Trig 4" |
5 |
"Pulse Trig 5" |
6 |
"Pulse Trig 6" |
Parameter
<char> signal direction for the specified connector:
INP |
Input |
OUTP |
Output |
Query Response
{INP|OUTP}
Related Commands
Equivalent Softkeys
Stimulus > Pulse Meas > Advanced Settings... > {Ext Trig Out | Ext Trig In | Pulse Trig 3 | Pulse Trig 4 | Pulse Trig 5 | Pulse Trig 6} -> {Input | Output}
Equivalent COM Command
None
Back to Pulse Measurement S5243
Back to Command Finder (From User Interface)
