SCPI Command
SENSe<Ch>:CORRection:COLLect:CKIT:STAN<Std>:Z0 <impedance>
SENSe<Ch>:CORRection:COLLect:CKIT:STAN<Std>:Z0?
Sets or reads out the offset Z0 value for the calibration standard. |
---|
command/query |
Standard <Std> of the calibration kit specified for channel <Ch>,
<Ch>={[1]|2|3|4}
<Ch>={[1]…|16} (in N-port mode only)
<Std>={[1]|2|...K}, where K — the number of the standards in the calibration kit
<impedance> the offset Z0 value from –1E18 to 1E18
Ω (Ohm)
Sets the value of the limit, which is closer to the specified value.
<numeric>
50 or 75 Ω, depending on the selected calibration kit
Calibration > Calibration Kit > Edit Cal Kit > Offset Z0
Equivalent COM Command
SCPI.SENSe(Ch).CORRection.COLLect.CKIT.STAN(Std).Z0
Value = app.SCPI.SENSe(Ch).CORRection.COLLect.CKIT.STAN(Std).Z0
app.SCPI.SENSe(Ch).CORRection.COLLect.CKIT.STAN(Std).Z0 = 50
Double (read/write)
Back to SENSe
Back to Command Finder
Back to Command Finder (From User Interface)