Please enable JavaScript to view this site.

 Network Analyzers using RVNA and RNVNA software

The flatness search function allows to determine and view the following trace parameters: gain, slope, and flatness. Two markers to specify the flatness search range should be set (See figure below).

Flatness search

Flatness search

Flatness parameters

Parameter Description

Symbol

Definition

Gain

gain

Marker 1 value.

Slope

slope

Difference between marker 2 and marker 1 values.

Flatness

flat

Sum of "positive" and "negative" peaks of the trace, which are measured from the line connecting marker 1 and marker 2 (See above figure).


To enable/disable a flatness search function, use the softkeys Markers > Math > Flatness on left menu bar.

Click on the Flatness field to toggle between the on/off status.

Flatness range is set by two markers. If there are no markers in the list, add two markers. Marker adding operation is described in Markers.

Click on the Flatness Start or Flatness Stop field and select the required marker numbers from the list.

Marker Math Flatness Flatness menu


Rev.:  24.1