SCPI Command
SENSe<Ch>:PORT<Port>:ATTenuation <Receiver>,<Value>
SENSe<Ch>:PORT<Port>:ATTenuation? <Receiver>
Description
Sets or reads out a specific receiver's attenuation setting. Before changing the receiver's attenuation setting, make sure the signal level into the receiver is low enough to avoid compression and damage to VNA receiver. |
|---|
command/query |
Target
Channel <Ch>
Port <Port>
Parameter
<Receiver> the receiver name, {Reference, Test} or {R, T}
<Value> the attenuation value
Unit
dB
Query Response
<numeric>
Related Commands
SYSTem:CAPability:ATTenuation?
Back to SENSe
Back to Command Finder
Rev.: 26.00