SCPI Command
AFR:SYSTem:STEP<St>:THRU: REFOFFSet {OFF|ON|0|1}
Description
Sets automatic calibration plane offset mode at the <Step> measurement step. The command disables manual input mode of the calibration plane offset if it was previously enabled by the AFR:SYST:STEP<Step>:THRU:OFFS {1|ON} command. Execution of the command is ignored if the measurements were not performed at step <Step>. To find out the state of the measurement step, use the AFR:SYST:STEP<Step>:MEAS? command. |
|---|
no query |
Target
Measurement step <Step>,
<Step> = {1|2|...}
Parameter
{ON|1} |
ON |
{OFF|0} |
OFF |
Related Commands
AFR:SYSTem:STEP<Step>:THRU:OFFSet
Related Controls of User Interface
Fixture measurement > Step <Step> of N > 2xThrough method > Apply fixture F1/F2 calibration plane offset
F1 - name of the left fixture,
F2 - name of the right fixture,
N - maximum number of steps.
