Please enable JavaScript to view this site.

 Network Analyzers using TRVNA software

Gauging connectors not only provides assurance of proper mechanical tolerances, and thus connector performance, but also indicates when there is potential for causing damage to another connector.

Connector gauging should be performed before the instrument is first used, and during regular operation.

The first gauging of connectors obtains the pin depth, which can be used during operation with the module to evaluate its changes.

Gauge the connectors if:

the device (instrument, calibration standard, cable, adapter, attenuator, or other RF item with coaxial connectors) is being used for the first time.

visual inspection of the Analyzer calibration suggests that the connector may have defects or damage.

the connectors of the device used with the Analyzer are damaged, or their pin depth values are out of the range for this type of connector.

the device is shared with someone else.

after every 100 connections or as often as experience suggests.

The procedure for connector gauging is as follows (See figure):

1. Select the proper gauge for your connector.

2. Inspect and clean the gauge, the gauge master, and the connectors to be gauged.

3. Zero the connector gauge before use (according to the gauge documentation).

4. Gauge the connector: while holding the gauge by the barrel, carefully connect the connector under test to the gauge. Read the gauge indicator dial value to determine recession or protrusion and compare the readings with the device specifications (See the figure and table below).


Note

Use multiple measurements and keep records of readings.



Note

Never use an out of specification connector.

Do not hold connector gauge by the dial.


Gage_master_male

Connector_male

Gauge Master, male

Connectors, male

Gage_master_female

Connector_female

Gauge Master, female

Connectors, female

Example of Gauging Connectors

Gaging_Conn N

Type-N Connectors (female and male)

Gaging_Conn 3_5

3.5 mm NMD Connectors (female and male)

Mechanical Requirements for Measured Connectors

The А pin depth value of connector

Connector type

А pin acceptable depth range

Type-N, female

5.18 to 5.26 mm

Type-N, male

5.28 to 5.36 mm

2.4 mm NMD, female

3.5 mm NMD, female

-0.08 to 0.00 mm

2.4 mm NMD, male

3.5 mm NMD, male

-0.08 to 0.00 mm

If the pin depth values of the gauged connectors are out of the acceptable range, the connectors may be eligible to be sent in for repair.

 

Rev.:  24.1