Please enable JavaScript to view this site.

 Network Analyzers using TRVNA software

Unpack the Analyzer and other accessories.


CAUTION

Please keep packaging to safely ship the instrument for annual calibration!


First, connect the earth terminal to the earth protection.

Install the TRVNA software from the shipped flash-drive or www.coppermountaintech.com on the PC that will be used to operate of the Analyzer. The software installation procedure is described in Software Installation.

Connect the Analyzer to a 100 to 240 VAC 50/60 Hz power source by means of the external power supply supplied with the instrument. Connect the USB-port of the Analyzer to the PC using the USB Cable supplied in the package.

Warm up the Analyzer for the time stated in its datasheet.

Assemble the test setup using cables, connectors, fixtures, etc., which allow DUT connection to the Analyzer.

Perform calibration of the Analyzer. Calibration procedures are described in Calibration and Calibration Kit.

 

Rev.:  24.1