SCPI Command
SENSe<ch>:PLS2:MEASurement:WIDTh <numeric>
SENSe<ch>:PLS2:MEASurement:WIDTh?
Description
Sets the measurement width, which is equal to the measurement width of one of the analyzer's digital IF filters. When setting an arbitrary value, the closest discrete value corresponding to the IF bandwidth is selected. Used in the “Point in Pulse”, “Pulse to Pulse”, “Narrowband” modes. Warning! The measurement width should not exceed the width of the modulation pulse in the wideband detection modes "Point in Pulse" and "Pulse to Pulse". The measurement must be performed within a single modulation pulse. In the "Narrowband" mode, the measurement width should be at least the width of a burst of N pulses, so that the energy of these pulses accumulates over the measurement width of the IF digital filter. It is recommended to set the value of N to at least 10. Note: S5243 model only. |
|---|
command/query |
Target
Channel <Ch> = {[1]|2| ... 16}
Parameter
<numeric> measurement width value.
Unit
sec (second)
Query Response
<numeric>
Preset Value
In wideband detection modes 5.04 µs
In narrowband mode 1.01 ms
Related Commands
Equivalent Softkeys
Stimulus > Pulse Meas > Meas Width
Equivalent COM Command
None
Back to Pulse Measurement S5243
Back to Command Finder (From User Interface)
