Please enable JavaScript to view this site.

 Network Analyzers using RVNA and RNVNA software

SCPI Command

SENSe<Ch>:SEGMent:DATA <numeric list>

SENSe<Ch>:SEGMent:DATA?

Description

Sets or reads out the array of the segment sweep table.

The array has the following format:

{<Buf>, <Flag1>, <Flag2>, <Flag3>, <Flag4>, <Flag5>, <N>,

<Start 1>, <Stop 1>, <NOP 1> [,<IFBW 1>] [,<Pow 1>] [,<Del 1>] [,<Time 1>],

<Start 2>, <Stop 2>, <NOP 2> [,<IFBW 2>] [,<Pow 2>] [,<Del 2>] [,<Time 2>],

<StartN>, <StopN>, <NOP N> [,<IFBW N>] [,<Pow N>] [,<Del N>] [,<TimeN>]}

<Buf> : Always 5,

<Flag1> Stimulus start setting (0 – start/stop, 1 – center/span),

<Flag2>  Setting of the <IFBW> field (0 – disabled, 1 – enabled),

<Flag3> Setting of the <Pow> field (0 – disabled, 1 – enabled),

<Flag4> Setting of the <Del> field (0 – disabled, 1 – enabled),

<Flag5> Setting of the <Time> field (0 – disabled, 1 – enabled),

<N> Number of segments,

<Start n> Start value of the n–th segment,

<Stop n> Stop value of the n–th segment,

<NOP n> Number of points of the n–th segment,

<IFBW n> IF bandwidth of the n–th segment (if enabled),

<Pow n> Power of the n–th segment (if enabled),

<Del n> Measurement delay of the n–th segment (if enabled),

<Time n> Reserved for future use (if enabled)

command/query

 

Target

Channel <Ch>,

<Ch>={[1]|2|3|4}

<Ch>={[1]…|16} (in N-port mode only)

Query Response

<numeric 1>,<numeric 2>,…<numeric 7+M×N>

Where:

N – the number of the segments,

M – depends on the values of the flags:

M = 3 + <Flag2> + <Flag3> + <Flag4> + <Flag5>

Equivalent Softkeys

None


Equivalent COM Command

SCPI.SENSe(Ch).SEGMent.DATA

Syntax

Data = app.SCPI.SENSe(Ch).SEGMent.DATA

app.SCPI.SENSe(Ch).SEGMent.DATA = Data

Type

Variant (array of Double) (read/write)


 

Back to SENSe

Back to Command Finder

Back to Command Finder (From User Interface)

 

Rev.:  24.1