The error correction status is indicated for each trace individually. There is also a general status of error correction for all traces of a channel.
General error correction status
The general error correction status for all S-parameter traces of a channel is indicted in the specific field on a channel status bar (See table below). For the channel status bar description, see Channel Status Bar.
Symbol |
Definition |
Note |
|---|---|---|
Cor |
Error correction is enabled. The stimulus settings are the same for the measurement and the calibration. |
If the function is active for all traces — black characters on a gray background. If the function is active only for some of the traces (other traces are not calibrated) — white characters on a red background. |
C? |
Error correction is enabled. The stimulus settings are not the same for the measurement and the calibration. Interpolation is applied. |
|
C! |
Error correction is enabled. The stimulus settings are not the same for the measurement and the calibration. Extrapolation is applied. |
|
Off |
Error correction is turned off. |
For all traces. White characters on a red background. |
--- |
No calibration data. No calibration was performed. |
The error correction status for each individual trace is indicated in the trace status field (See table below). For trace status field description, see Trace Status Field.
Symbols |
Definition |
|---|---|
RO |
OPEN response calibration |
RS |
SHORT response calibration |
F1 |
Full one-port (SOL) calibration |
ST |
Transmission normalization (RNVNA only) |
F1ST |
Full one-port calibration with transmission normalization (RNVNA only) |
F2ST |
Full two-port calibration with transmission normalization (RNVNA only) |
MATH |
Equivalent to F2ST Calibration, obtained by mathematical method (RNVNA only) |
