Please enable JavaScript to view this site.

 Network Analyzers using TRVNA software

The electrical delay function compensates for the electrical delay of the trace measurement. This function is useful during measurements of phase deviations from linear, for example.

If the electrical delay setting is other than zero, the S-parameter value will be corrected in accordance with the following formula:

,

where frequency, Hz,

electrical delay, sec.

The electrical delay can be specified in seconds.

The electrical delay is set for each trace independently. The trace to which the function is applied must be preselected as active (See Selection of Active Trace/Channel ).

Scale

Electrical Delay Softkey

To set the electrical delay in seconds, use the following softkeys:

Scale > Electrical Delay

 

 

 

 

Rev.:  24.1