The stimulus power level should be set for the linear and logarithmic frequency sweeps.
For the segment sweep type, the method of power level setting described in this section can be used only if the same power level is set for all the segments of the sweep. For setting of individual power levels for each segment, see Segment Table Editing.
The channel to which the function is applied must be preselected as active (See Selection of Active Trace/Channel).
|
To enter the power level value when port couple feature is ON, use the following softkeys: Stimulus > Power > Power |
|
|
Setting the Power Level for Each Port
By default, the power levels of all test ports are set to equal value. This function is called Port Couple. This function can be optionally disabled, and the power level of each port can be set individually.
|
To set the power level for each port individually, first disable the Power Couple function: Stimulus > Power > Port Couple [ON | OFF] |
|
Then set the power level for each port: Stimulus > Power > Port Power > [Port 1 | Port 2 | Port 3 | Port 4] |
|
|
note |
Setting the Power level is possible using the mouse (See Power Level/CW Frequency Setting). |
