SCPI Command
SENSe<ch>:PLS2:MODE {OFF|PIP|NBW|PROF|HIPR|PTOP}
SENSe<ch>:PLS2:MODE?
Description
Turn pulse measurements on and sets their mode. Note: S5243 model only. |
|---|
command/query |
Target
Channel <Ch> = {[1]|2| ... 16}
Parameter
<char> defines the mode:
OFF |
Pulse mode disabled |
PIP |
"Point-in-pulse" — frequency response of the DUT is measured using wideband detection |
NBW |
"Narrowband" — frequency response of the DUT is measured using narrowband detection |
PROF |
"Pulse profile" — pulse parameters (amplitude envelope and pulse phase) are measured in the time domain at the width of one pulse |
HIPR |
"Pulse profile high resolution" — pulse profile is measured with higher time resolution by using a series of pulses instead of one pulse |
PTOP |
"Pulse to pulse" — the drift of DUT parameters is tracked during the action of one burst of pulses with same carrier frequency |
Query Response
{OFF|PIP|NBW|PROF|HIPR|PTOP}
Preset Value
OFF
Equivalent Softkeys
Stimulus > Pulse Meas > Pulse Mode
Equivalent COM Command
None
Back to Pulse Measurement S5243
Back to Command Finder (From User Interface)
