The electrical delay function compensates for the electrical delay of the trace measurement. This function is useful during measurements of phase deviations from linear, for example.
If the electrical delay setting is other than zero, the S-parameter value will be corrected in accordance with the following formula:
,
where — frequency, Hz,
— electrical delay, sec.
The electrical delay is set for each trace independently. The trace to which the function is applied must be preselected as active (See Active Trace Selection).
To set the electrical delay, use the following softkey Scale. Then select the Electrical Delay field and enter the required value using the on-screen keypad.
|
Rev.: 24.1