SCPI Command
SYSTem:COMMunicate:ECAL:CHECk
Sets the CHECK state of the AutoCal module, in this case, the "attenuator" state is set between the ports of the AutoCal module. Note: The Module features additional attenuator state, which is not used during calibration. The attenuator is used for checking calibration quality using a special confidence check function, which allows for comparing of the measured S-parameters of attenuator with the parameters stored in the Module memory. |
---|
command only |
None
Back to SYSTem
Back to Command Finder
Back to Command Finder (From User Interface)