Please enable JavaScript to view this site.

 Network Analyzers using PXI software


note

Install the software before inserting the PXIe-S5090 hardware to the PXIe chassis.


 

Minimal system requirements to hardware

PXIe system running WINDOWS 7 or higher (64 or 32 bit variant)

Prerequisite software required

NI FlexRIO Driver

NI-VISA

IVI Shared Components

Installation file

Setup_PXIe_S2VNA_vX.X.exe

Components installed

During installation the following components will be installed:

S2VNA.exe main GUI application

PXIe VNA hardware driver

USB driver for using with automatic calibration module

IVI-C driver (both 64 and 32 bit variants)

IVI.NET driver (both 64 and 32 bit variants)

Labview driver (both 64 and 32 bit variants)

Documentation including operating and programming manual

Power-on Utility which is used to warm up the Analyzer at system start-up

 

1. Verify that the following software components are installed on the PXIe system on which the PXIe-S5090 software depends. Install them if necessary:

NI FlexRIO Driver

NI-VISA

IVI Shared Components

2. Install the CMT PXIe-S5090 VNA software.

2.1 Download the installation file Setup_PXIe_S2VNA_vX.X.exe from the Copper Mountain Technologies web site.

2.2 Run the Setup_PXIe_S2VNA_vX.X.exe installer file onto embedded controller in the PXIe chassis. Follow the instructions of the installation wizard.

3. Re-boot the PXI chassis.

Rev.:  22.3