Please enable JavaScript to view this site.

 Network Analyzers using PXI software

A channel state and channel calibration can be saved into the Analyzer memory.

The channel state saving procedure is similar to that of Analyzer state saving, and the same saving types (See Analyzer State) are applied to the channel state saving function.

Unlike the Analyzer state, the channel state is saved into the Analyzer’s inner volatile memory (not to the hard disk) and is cleared when the Analyzer is turned off. For channel state storage, there are four memory registers: A, B, C, D.

The channel state saving function allows to copy easily the settings of one channel to another one.

Channel State Saving

Save_Recall

Save Channel

To save the active channel state, use the following softkeys:

Save/Recall > Save Channel

State A_D

To save a state into one of the four memory registers, use the State A…State D softkeys.

A check mark in the left part of the softkey indicates that the state with the corresponding number is already saved.

 

Clear States

To clear the all channel state, use the Clear States softkeys.

 

 

 

Channel State Recalling

Save_Recall

Recall channel

To recall the active channel state, use the following softkeys:

Save/Recall > Recall Channel

State A_D_grey

Click the required softkey from those available: State A…State D.

If the state with a certain number was not saved, the corresponding softkey will be grayed out.

 

 

 

 

Rev.:  22.3