Please enable JavaScript to view this site.

Automatic Calibration Module

The front panels of the different models of ACM4000T are shown in the figure below.

ACM4000

Front panel ACM4000T

Parts of Module

Test port

The test ports are designed for connection to VNA being calibrated. The VNA connectors, the cross sections of which were calibrated, are referred to as its test ports.

The Modules connectors are shown in figures below.

Type N 75 ohm male

Type N 75 Ohm female

Type N 75, male

Type N 75, female

Connector (on side panel)

Mini USB

The connector is located on the bottom of the Module and is intended for the Module connection to the controlling PC. The Module is powered using the USB cable.

Hardware configurations

Model

Connector type

Port A

Port B

ACM4000T-511

type N 75, female

type N 75, female

ACM4000T-512

type N 75, male

type N 75, female

 

Rev.:  22.1