SCPI Command
SENSe:SWEep:PULSe:TRIGger:READy {OFF|ON|0|1}
SENSe:SWEep:PULSe:TRIGger:READy?
Description
Enables "Ready for Pulse" signal. The Analyzer outputs this signal to the "Pulse 1 Out" connector when the following conditions are met: •The synchronous pulse mode (Point-in-pulse or Pulse Profile modes) is active. •The pulse trigger source is set to external. •The Analyzer is ready for the next trigger pulse. Note: S5180B model only. |
|---|
command/query |
Target
Analyzer
Parameter
{ON|1} |
Enables "Ready for Pulse" signal to be routed to "Pulse 1 Out" connector. |
{OFF|0} |
Disables "Ready for Pulse" signal. |
Query Response
{0|1}
Preset Value
0
Equivalent Softkeys
Stimulus > Pulse Meas > Ready for Pulse
Equivalent COM Command
None
Back to Pulse Measurement S5180B
Back to Command Finder (From User Interface)
Rev.: 24.1