Please enable JavaScript to view this site.

 Network Analyzers using RVNA and RNVNA software

The Module is controlled by the Copper Mountain Technologies VNA software. Minimum technical requirements to the PC and the description of software installation are described in the VNA Operating Manual.

The VNA software automatically detects the connected Module and makes the Autocalibration menu available. Special Module selection is not generally required.

If the menu is not active:

1. Shut down all the open VNA software windows.

2. Disconnect the Module from the USB cable for one minute, then reinsert the cable.

3. Restart the VNA software, making sure that the VNA software functions properly according to the VNA Operating Manual.

4. Connect the Module again, making sure that the model and serial number match the Module connected.

Driver installation

The USB driver is automatically installed when the Module is first connected to the USB port.

 

Rev.:  24.1