Demo mode is designed to simulate DUT measurement. The measurement results of the DUT are pre-recorded in the software memory. Any Analyzer model can be selected from the list of supported devices in demo mode.
note |
The simulation of the Analyzer in demo mode may differ from the real measurements of the analyzer. For example, the accuracy of the sweep time dependence on the IF filter setting is not guaranteed. |
|
To enable/disable the demo mode: Settings > VNA Devices [Demo] > Connect/Disconnect The Connect/Disconnect button can be seen by hovering over the right side of the device menu.
|
note |
Demo mode is automatically enabled when the software is downloaded. Connect a device in the VNA Devices menu to disable demo mode |
Rev.: 25.00